After the foam strip is tightly and completely wrapped around the bar assembly cut another straightedge to mate evenly with the first straightedge, ensuring that there are no gaps or overlaps along the two edges. If necessary, re-stretch and trim the foam strip to mate evenly with the first edge. Для нужд АТО. Может вам или кому-то из ваших товарищей это интересно? Frequency coverage 1 kHz-30 MHz + 50-54 MHz, variable bandwidth 2.5 Hz to 20.44 kHz in 2.5-Hz increments. Забота о вас, и всё такое. НО ЭТО НЕРЕАЛЬНО РАЗДРАЖАЕТ, КОГДА ТЫ ЕДЕШЬ ГДЕ-ТО, и уровень станции постоянно меняется. This factor (along with the use of a grounded shield around the lead-in Litz wires) has proven to have a major effect on the nulling capability of the FSL coil. After this trimming both edges of the assembly should be flat, with the assembly forming a perfect cylindrical shape (as shown). 9) Refer to the photo below: Place the assembly on one of its edges, as shown.
Then insert and tighten the left upper and left lower cabinet screws thoroughly, while snapping the right lower cabinet sections together. Also ensure that the Litz wires are in the position shown, with no pinching or binding between the FSL assembly and antenna frame. Because of this, careful attention to the instructions and the use of the recommended ferrite bars and Litz wire is important for the best performance. That overcomes the huge problem of interminable button pushing or knob twisting to go to a station and is the reason this radio will get used and the others will stay on the radio shelf.
Так же в прёмнике TECSUN PL360 реализована новая функция — ETM (Easy Tuning Mode) – режим легкой настройки. Раньше жил а Баку,в конце 80-х переехал в Белую Церковь. This auction is almost over and you’re currently the high bidder. Get a PayPal account here . Your bid is the same as or more than the Buy It Now price.You can save time and money by buying it now.